Allied Telesis AT-x230-18GP - Manual (Page 62)

Chapter 2: Installation
52
Powering on the switch
To power on the AT-x230-10GP or AT-x230-18GP switch, perform the
following procedure:
1. Lift the power cable hook, as shown in Figure 23, on the back of the
switch.
F IGURE 23. L IFTING THE AC POWER CABLE HOOK ON AN X 230 S ERIES
S WITCH
Power cable hook
Power cable hook mount
2. Plug the power cord into the AC power connector, as shown in
Figure 24, on the back of an AT-x230-10GP or AT-x230-18GP switch.
F IGURE 24. P LUGGING IN THE AC POWER CORD ON AN X 230 S ERIES S WITCH
Power cable