Allied Telesis AT-TQ Series - Manual (Page 79)

AT-TQ Wireless Access Point Series User’s Guide
79
7. After configuring the encryption settings, click the Update button to
activate and save your changes on the access point.
8. Log off to end your management session on the access point.
9. Start a management session on the other access point of the WDS
bridge.
10. Repeat “Preparing the Access Point for the WDS Bridge” on page 76
and this procedure to configure the WDS bridge on the other access
point. Be sure to assign the same values to the parameters.
Static WEP The static WEP parameters are shown in Figure 23 and described in
Table 9.
Figure 23. Static WEP on WDS Bridges
Table 9. Static WEP on WDS Links
Field Description
Key Length Select either 64 or 128 bits for the key
length. The default is 128 bits.
Key Type Select either ASCII or hexadecimal for the
key type. The default is hexadecimal.