Allied Telesis AT-SBx3106WMB - Manual (Page 32)

Installation Instructions
32
Installing the Brackets on the Chassis
This procedure installs the wall brackets on the chassis.
Note
Do not remove the shipping brace from the front of the chassis until
after the unit is installed on the wall. You might bend the chassis and
cause misalignment of the slots and card guides if you lift the
chassis without the shipping brace. You should reinstall the shipping
brace if you have already removed it. Refer to Figure 13.
Caution
If the chassis already contains line cards and power supplies, you
should remove them and reinstall the shipping brace before
installing the chassis on the wall.
Figure 13. Shipping Brace
To install the brackets on the chassis, perform the following procedure:
1. With a #2 Phillips-head screwdriver, remove the two pre-installed rack
mount brackets from the sides of the chassis. Refer to Figure 14 on
page 33.
Shipping Brace