Allied Telesis AT-GS950/8 - Manual (Page 136)

Chapter 10: MAC Address Table
136
Static Multicast Address Configuration
This procedure explains how to set the static multicast feature for each
port on the AT-GS950/8 switch. Before beginning this procedure, you
must create an 802.1Q VLAN ID or a Port-Based VLAN Index. For
information about defining these parameters, see:
 “Tagged VLAN Configuration” on page 166 regarding the 802.1Q
VLAN parameter.
 “Port-Based VLAN Configuration” on page 173 regarding the Port-
Based VLAN parameter.
To add a static multicast MAC address to the switch, perform the following
procedure:
1. From the main menu on the left side of the page, select the Bridge
folder.
The Bridge folder expands.
2. From the Bridge folder, select Static Multicast.
The Static Multicast Address Table Page is displayed.
See Figure 46.
Figure 46. Static Multicast Address Table Page
3. Select either the 802.1Q VLAN or Port-Based VLAN radio button and
enter the respective VLAN ID (1-4093) or VLAN Index (1 - 52).