Allied Telesis AT-GS950/8 - Manual (Page 322)

Chapter 25: Loopback Protection
322
Configuration
To configure the Loopback Detection feature, perform the following
procedure:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select Loopback Detection.
The AT-GS950/8 Loopback Detection Page is displayed. See
Figure 116.
Figure 116. AT-GS950/8 Loopback Detection Page
3. For the Loopback Detection State field a the top of the page, select
one of the following radio buttons:
Enabled - This selection enables the Loopback Detection feature
across the switch. This state must be enabled for the individual
port Loopback Detection State is effective.
Disabled - This selection disables the Loopback Detection feature
on the switch.