Installing the switch in a rack – Allied Telesis AT-GS900/24 User Manual
Page 37
AT-GS900/16, AT-GS900/24 Gigabit eco-friendly Ethernet Switch Installation Guide
37
Installing the Switch in a Rack
Perform the following procedure to install the switch in a standard 19-inch
rack. If you are not installing the switch in a rack, go to the next procedure.
1. Place the unit upside down on a level, secure surface.
2. If they have been previously installed, remove the self-adhesive rubber
feet from the bottom of the switch, as shown in Figure 9 using a flat-
head screwdriver.
Figure 9. Removing the Feet
3. Turn the switch over.
4. Attach the two rackmounting brackets (provided) to the sides of the
switch using the eight flathead Phillips screws (provided), as illustrated
in Figure 10.
Figure 10. Attaching Rack Mounting Brackets
1920
24 Port 1
0/100/10
00Base-T
Gigabit E
thernet
Switch
1
3
5
7
9
11
13
15
17
19
21
23
2
4
6
8
10
12
14
16
18
20
22
24
18
20
22
24
10
12
14
16
2
4
6
8
9
11
13
15
1
3
5
7
17
19
21
23
POWER
10/100 LINK
ACT
1000 LINK
ACT
FDX
HDX
COL
AT-GS900/24