Allied Telesis AT-FS750/48 - Manual (Page 47)

AT-FS750/48 Fast Ethernet WebSmart Switch Installation Guide
47
Connecting the
Fiber Optic
Cables
To connect a fiber optic cable to an SFP transceiver installed in the AT-
FS750/48 Fast Ethernet WebSmart switch, perform the following
procedure:
Note
If you plan to configure a redundant data path, make sure that the
Spanning Tree feature is enabled via the AT-S105 Management
Software before connecting the ethernet cables for your secondary
network connections.
1. Remove the dust plug from the SFP transceiver, as shown in
Figure 17.
Figure 17. Removing the Dust Plug from the SFP Transceiver
2. Connect the fiber optic cable to the SFP port, as shown in Figure 18.
Figure 18. Connecting the Fiber Optic Cable
1714 48 Port 10/100 Mbps
WebSmar
t Switch with 2 Combo SFP
Ports
1739
1714 48 Port 10/100 Mbps
WebSmar
t Switch with 2 Combo SFP
Ports
1740