Allied Telesis AT-CV5001 - Manual (Page 40)

Chapter 2: Installation
40
3. The power supply can be installed in either slot A or slot B. If this is the
initial installation and if you are installing just one power supply, Allied
Telesis recommends installing the module in slot A because that slot
does not have a cover. If you want to install the module in slot B,
remove the cover from the slot by loosening the two captive screws
with a cross-head screwdriver.
Figure 13. Removing the Cover from Slot B
WA RNING This unit might h
ave more than one p
ower input
. To reduce the risk
of electric sho
ck, disconnect all p
ower inputs be
fore se rvicing unit
.
o
B
1681
WA RNIN G This unit might h
ave more than one p
ower input
. To reduce the risk
of electric shoc
k, disconnect all po
wer inputs bef
ore ser vicing unit. o
B
1682