Allied Telesis AT-9448Ts/XP (Basic Layer 3) - Manual (Page 60)

Chapter 2: Installing the Switch
60
Applying AC Power
To apply AC power to the switch, perform the following procedure:
1. Position the power cord retaining clip in the up position, as shown in
Figure 26.
Figure 26. Power Cord Retaining Clip in the Up Position
2. Plug the power cord into the AC power connector on the back panel of
the unit (see Figure 27).
.
Figure 27. Connecting the AC Power Cord
Warning: Power cord is used as a disconnection device. To de-
energize equipment, disconnect the power cord.
 E3
Warning: This unit might have more than one power cord. To
reduce the risk of electric shock, disconnect all power cords
before servicing the unit.
 E30
100-240V
AC ~
100-240V
AC ~