Allied Telesis AT-S94 - Manual (Page 28)

Configuring Internet Protocol Version 6
Page 28
– Tunnel
• Type — Specifies the means by which the default gateway was configured. The possible field values are:
– Static — Indicates the default gateway is user-defined.
– Dynamic — Indicates the default gateway is dynamically configured.
• State — Displays the default gateway status. The following states are available: Incomplete, Reachable,
Stale, Delay, Probe and Unreachable.
2. Select an Interface.
3. Click Add. The Add Static Default Gateway Page opens.
Figure 12: Add Static Default Gateway Page
4. Define the Default Gateway IPv6 Address field for the IP Interface. The address must be a valid IPv6
address, specified in hexadecimal using 16-bit values between colons. An example of an IPv6 address is
2031:0:130F:0:0:9C0:876A:130D and the compressed version is represented as 2031::0:0:9C0:876A:130D.
5. Click Apply. The default gateway is defined, and the device is updated.