Set lacp state – Allied Telesis AT-S63 User Manual
Page 172
Chapter 10: LACP Port Trunking Commands
172
Section I: Basic Operations
SET LACP STATE
Syntax
set lacp state=enable|disable
Parameters
state
Specifies the state of LACP on the switch. The options are:
enable
Enables LACP.
disable
Disables LACP. This is the default.
Description
This command enables or disables LACP on the switch.
Caution
Do not disable LACP if there are defined aggregators without first
disconnecting all cables connected to the aggregate trunk ports.
Otherwise, a network loop might occur, resulting in a broadcast
storm and poor network performance.
Example
The following command activates LACP on the system:
set lacp state=enable
Equivalent Commands
disable lacp
For information, see “DISABLE LACP” on page 167.
enable lacp
For information, see “ENABLE LACP” on page 168.