Allied Telesis AT-GS900/8POE - Manual (Page 44)

Chapter 2: Installation
44
Cabling an SFP
Transceiver
To cable an SFP transceiver, perform the following procedure:
Warning
Class 1 laser product.  L1
Warning
Do not stare into the laser beam.  L2
Note
For information about the proper cable type, refer to the
documentation that accompanied the SFP transceiver.
Note
Before you install the cable in the SFP transceiver, verify that the
optical power input to the transceiver is within its dynamic range.
1. Remove the dust cover from the SFP transceiver, as shown in
Figure 12.
Figure 12. Removing the Dust Cover from the SFP Transceiver
7
8R
CLASS 1 LASER PROD UCT
1000Ba
se-X
PD ON
PD ER ROR
1000 LINK
ACT 10/100 LINK
ACT
PORT ACTIV
ITY
970
8
SFP