Allied Telesis AT-MCR1 - Manual (Page 26)

Chapter 2: Installation
26
Installing the Chassis Under a Table (AC
Models Only)
The AT-MCR1 chassis can be mounted under a table using the
mounting brackets shipped with the chassis.
Note
Make sure that the under-table location provides easy access
for installing the twisted pair, fiber optic, and power cables to
and from the chassis.
Note
Before you install the AT-MCR1 chassis under a table, install
the cables. For cabling instructions, refer to the installation
guide that is shipped with the Allied Telesis media converter.
To install an AT-MCR1 chassis under a table, perform the
following procedure:
1. If attached, remove the rubber feet and power cord from the
chassis.
2. Select a location under a table and mark two hole locations
for the mounting screws.
Caution
The mounting brackets provided in the chassis package must
be used to securely install the chassis under the table.