Allied Telesis AT-S86 - Manual (Page 30)

Chapter 2: Basic Switch Parameters
30
Enabling or
Disabling IP
Access
To enable or disable IP access for the users, perform the following
procedure:
1. From the main menu, select System > IP Access List.
The IP Access List page is shown in Figure 6 on page 28.
2. From the IP Restriction is list, choose one of the following:
Disabled - Disables IP restriction. This is the default.
Note
Before you enable IP access, remember to add your own IP address
to the list. Otherwise, you will not be able to access the switch.
Enabled - Enables IP restriction.
3. Click OK.
4. To permanently save these settings in the configuration file, from the
main menu, select Save Configuration.
The Save Configuration page is shown in Figure 3 on page 21.
5. Click Save.