Allied Telesis AT-CV5000 - Manual (Page 77)

AT-CV5000 Media Converter Chassis Installation Guide
77
4. Slide the management card into the slot, as shown in Figure 50, until
the front of the card is flush with the front of the chassis.
Figure 50. Inserting the AT-CV5M01 Management Card
5. Secure the AT-CV5M01 Management Card to the chassis by using a
Phillips screwdriver to tighten the captive screw on the management
card faceplate, as shown in Figure 51.
Figure 51. Tightening the Captive Screw
Note
Always tighten the captive screw to secure the management card to
the chassis. Leaving a management card partially seated may cause
the CPU to halt and subsequently crash.
Resetting an
AT-CV5M01
Management
Card
To reset the AT-CV5M01 Management Card, perform the following
procedure.
1. Locate the CPU RESET button which is recessed in the front panel of
the AT-CV5M01 Management Card.
7
8
9
10
241
AT-CV
5M01
PWR RD Y FL T
CPU RES ET
LK A T FD
AT-CV5M01
PWR RD Y FL T
CPU RE SET
LK A T FD
243