Allied Telesis AT-2972T/2 - Manual (Page 66)

Installing Windows 2000 Driver Software
66
5. From the Properties list, select Speed/Duplex.
6. From the Values list, select one of the following:
ˆ 10 Mb Full. Sets the speed at 10 Mbit/s and the mode to Full-
Duplex.
ˆ 10 Mb Half. Sets the speed at 10 Mbit/s and the mode to Half-
Duplex.
ˆ 10 Mb Half and 100 Mb Half settings force the network adapter to
connect to the network in Half-Duplex mode. The network adapter
may not function if the network is not configured to operate at the
same mode.
ˆ 100 Mb Full. Sets the speed at 100 Mbit/s and the mode to Full-
Duplex.
ˆ 100 Mb Half. Sets the speed at 100 Mbit/s and the mode to Half-
Duplex.
ˆ 10 Mb Full and 100 Mb Full settings force the network adapter to
connect to the network in Full-Duplex mode. The network adapter
may not function if the network is not configured to operate at the
same mode.
ˆ Auto (default). Sets the speed and mode for optimum network
connection (recommended). This setting allows the network
adapter to dynamically detect the line speed of the network.
Whenever the network capability changes, the network adapter
automatically adjusts to the new line speed and duplex mode. A
speed of 1 Gbit/s is enabled by selecting Auto, when that speed is
supported.
7. Click OK.
8. If prompted to restart your computer, click Yes.
Even though it is not necessary to reboot the system for new adapter
properties to take effect, rebooting is recommended to reinitialize all
registers.
9. Verify that the adapter port LEDs operate as described in “LEDs” on
page 19.
Wake Up
Capabilities
(AT-2972/T2
only)
The Wake Up Capabilities property enables the network adapter to wake
up from a low-power mode when it receives a network wake-up frame.
Two types of wake-up frames are possible: Magic Packet and Wake Up
Frame.
To specify the wake up capabilities, perform the following procedure:
1. Start either a Windows Server 2003 or a Windows XP system and log
in.