Example – Allied Telesis AT-S63 User Manual
Page 46
Advertising
Chapter 3: Basic Switch Commands
46
configuration file, the configuration file the switch uses the next time it is
reset. If you reset or power cycle the switch, the switch uses the previous
configuration. To change the active boot configuration file, refer to “SET
CONFIG” on page 173.
Your local or remote management session with the switch ends when you
reset the switch. You must reestablish the session to continue managing
the switch.
Example
The following command configures the switch using the configuration file
named
switch12.cfg
:
restart switch config=switch12.cfg
The following command resets the switch to its default values:
restart switch config=none
Advertising