Allied Telesis AT-FS705LE User Manual
Page 36
Installation
24
•
You should check to be sure that you are
using the appropriate type of twisted pair
cabling. Refer to Table 4 on page 10 for
twisted pair cable specifications.
•
Since the twisted pair port, when operating
in Auto-Negotiation, is Auto MDI/MDI-X,
you can use either a straight-through or
crossover twisted pair cable to connect any
type of network device to a port on the
switch. If you disable Auto-Negotiation on
the port, the port defaults to MDI-X.
6. Apply power to the switch by plugging the
AC/DC power adapter into an AC power
outlet, the plug the DC connector to the power
receptable of the switch.
Warning
The power cord is used as a
disconnection device. To de-energize
equipment, disconnect the power cord.
5
7. Verify that either the PWR LED is green. If
the LED is OFF, refer to “Troubleshooting” on
page 27 for instructions.