Allied Telesis AT-8550 - Manual (Page 26)

IP OSPF Commands
24
config ospf spf-hold-time {<seconds>} Configures the minimum number of seconds between Shortest Path
First (SPF) recalculations. The default setting is 3 seconds.
config ospf spf-hold-time {<seconds>} Configures the minimum number of seconds between Shortest Path
First recalculations. The default setting is 3 seconds.
config ospf [vlan <name> | area <areaid> |
virtual-link <routerid>] timer
<retransmission_interval>
<transmission_delay> <hello_interval>
<dead_interval> Configures the timers for one interface or all interfaces in the same
OSPF area. The following default, minimum, and maximum values
(in seconds) are used:
❑ retransmission_interval
Default: 5
Minimum: 0
Maximum: 3,600
❑ transmission_delay
Default: 1
Minimum: 0
Maximum: 3,600
❑ hello _interval
Default: 10
Minimum: 1
Maximum: 65,535
❑ dead_interval
Default: 40
Minimum: 1
Maximum: 2,147,483,647
config ospf [vlan <name> | area <areaid> |
virtual-link <routerid>] timer
<retransmission_interval>
<transmission_delay> <hello_interval>
<dead_interval> Configures the timers for one interface or all interfaces in the same
OSPF area. The following default, minimum, and maximum values
(in seconds) are used:
❑ retransmission_interval
Default: 5
Minimum: 0
Maximum: 3600
❑ transmission_delay
Default: 1
Minimum: 0
Maximum: 3600
❑ hello _interval
Default: 10
Minimum: 1
Maximum: 65535
❑ dead_interval
Default: 40
Minimum: 1
Maximum: 2147483647
config ospf vlan <name> area <areaid> Associates a VLAN (router interface) with an OSPF area. All router
interfaces must have an associated OSPF area. By default, all router
interfaces are associated with area 0.0.0.0.
create ospf area <areaid> Creates an OSPF area. Area 0.0.0.0 does not need to be created. It
exists by default.
Command Description