Allied Telesis FastPrint Server - Manual (Page 27)

Chapter 4. Novell NetWare
Using PCONSOLE / PSCONFIG
FastPrint Server User’s Guide
17
1. 1. Create queue objects Create queue objects
Note: If you are using existing queues, go to step 2.
(a) Login to NetWare as ADMIN or a user with Admin rights.
(b) Run the PCONSOLE program.
(c) Select Print queues.
(d) Press [I NS ] key to add a new queue.
(e) Type a queue name, and press [E NTER ].
(f) Repeat steps (c) to (e) until you have the desired number of queues.
2. 2. Create printer objects Create printer objects
(a) From the PCONSOLE Main Menu, select Print servers.
(b) Select a NetWare Print Server.
(c) Select Printers.
(d) Press [I NS ] Key to insert a printer.
(e) Enter the correct information in the Name Field. (Refer to Remote printer
assignments on page 15.)
(f) Select the printer.
(g) In the Type field, select parallel for parallel port 1, 2, or 3.
(h) Select Configuration
(i) In the Port field, select LPT1 for parallel port 1, LP2 for parallel port 2 or LPT3
for parallel port 3.
(j) In Location field, set to Manual Load.
(k) Press [E SC ] to exit Configuration sub-menu.
3. 3. Associate queue objects and print objects Associate queue objects and print objects
Follow the instructions below to associate the printers with the queues to be serviced:
(a) Select Print queues assigned.
(b) Press [I NS ].
(c) Select the queue that you want the printer to service.
(d) Press [E SC ] twice.
(e) Repeat steps 2(d) to 3(d) until all associations between queues and printers are
completely configured.
(f) Exit PCONSOLE.
4. 4. Configure the FastPrint Server Configure the FastPrint Server
(a) Run PSCONFIG.
(b) Select your FastPrint Server.
(c) Select Set to NetWare Remote Printer Mode.
(d) Enter the NetWare Print Server Name selected in step 2(b) for all print ports.
(e) Select Execute Setup.
5. 5. Unload and Reload Pserver Unload and Reload Pserver
If the NetWare Pserver, to which the FastPrint Server has been installed, has been
previously loaded, you must unload and reload it. Start at step (a).