Hubbardton Forge 206425 - Manual

Installation Instructions
B279
Axis Vintage Platinum Sconce 20-6420 & 20-6425 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 28078
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
Fixture should be mounted four feet above grade.
After installation extra hardware and accessories are possible; our kits are used on multiple products and options.
To Install Fixture (Figures 1 & 2)
Component Parts
A Fixture Front
B Screw
C Fixture
D Crossbar
E #8 Screw (2)
F Ground Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Loosen the screw (B) in the bottom of the fixture (C) until the fixture front (A) will
come loose from the fixture back. Move the fixture front (A) towards the top of the
fixture (C) to remove (Figure 1).
3. Using two machine screws (not provided) attach crossbar (D) to the
electric box using inside oval holes to orient fixture. Note: A new
electric box comes with screws. When replacing a fixture, retain the
screws for use with the new fixture.
4. Using suitable wire connectors (not provided), connect the fixture wires
to the supply wires, (white to white, black to black). Run a pigtail lead
from crossbar ground screw (F) to the junction box and connect all
ground wires (bare copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely and no
bare wires are exposed.
5. Carefully tuck all wires behind the fixture, place fixture firmly against
the wall and fasten with two #8 screws (E). To ensure a water tight seal,
apply a thin bead of caulking around entire perimeter of the fixture.
6. Continue with installation instructions following to assemble fixture
front and glass.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)