Hubbardton Forge 104815 - Manual

Installation Instructions
A212
For Beacon Hall Four Light Chandelier 10-4815 & 10-4815E Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22850
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products and
options.
To Install (Figure 1)
Component Parts
A Crossbar
B Lock
Nut
C Nipple
D Canopy
E Loop
Collar
F Canopy Loop
G Chain
H Fixture
Loop
I Fixture
J Ground
Screw
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar to the electric
box.
Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.
3. Thread the nipple (C) into the crossbar (A) and secure with lock nut (B);
slide canopy (D) over nipple, and attach the canopy loop (F) to the nipple.
Adjust the nipple to proper length to ensure a snug canopy fit before
proceeding.
4. Attach one end of the chain to the fixture loop (H). Lace the wire through
every other link of the chain (G) to the end. Slip wires and chain through the
loop collar (E), canopy loop (F) and canopy (D). Fasten the chain to the
canopy loop, then slip wires through the loop and nipple, into the electric
box. Make sure to provide enough slack in the wire to ensure weight of
fixture is supported by the chain.
5. Using suitable wire connectors (not provided) connect fixture wires to supply
wires (white to ribbed side of the fixture cord, black to smooth side). Connect
all ground wires to crossbar ground screw (J).
Caution: Make sure wire connectors are twisted on securely, and no bare
wire is exposed.
6. Raise canopy to the ceiling and secure collar to canopy loop (F) with loop
collar (E).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)