Hubbardton Forge 121026 - Manual

Glass Installation Instructions
A50
For Hanging Pendants with Banded Glass Page 1 of 2
Please see reverse side for Fixture Installation Instructions.
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
To Install Glass
1. Attach bands (A) to glass (B) by placing band sections around lip of glass and securing with countersunk screws (C)
(Figure 1).
Note: On each band, one hole is threaded and the other is not. Screws must go through the unthreaded hole then
into the threaded hole of the next band.
2. To attach arm to band, grasp the arm so that the larger curled loop is toward the bottom with the tip toward the left.
Start the tip of the loop through one of the rings on the band. Twist the arm 360 degrees, guiding the curl through
the ring, until the curl is completely around the ring as shown in the illustration. Repeat the process for the
remaining arms (Figure 2).
3. To attach the glass to the fixture, position the glass over the fixture body and secure the top curl of each of the arms
to the hooks on the fixture.
Figure 1
Figure 2
(continued)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 15652