Hubbardton Forge 133303 - Manual (Page 2)

Assembly & Installation Instructions
A247
Kirigami Three Light Pendant 13-3303 Page 2 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 24617 Rev A
3. Slide the canopy pipe (G) as far as necessary to give you the total length of
the fixture which you desire. Be careful not to scratch the pipe surfaces and
to pull excess wire up through the canopy pipe (G). There must be a
minimum 1-1/2" of inner pipe inside the outer pipe. Screw clutch (J) onto
canopy pipe and hand-tighten the clutch to temporarily hold this adjustment.
The clutch is not securely fastened at this point; do not depend on it to hold
the fixture.
Important: To ensure full connection strength, be sure the tapered end of
the plastic clutch sleeve is oriented toward the clutch when assembled and
securely tighten set screw (Figure 2).
4. Using two machine screws (not provided), fasten the crossbar (B) to the
electric box.
Note: A new electric box comes with screws. When replacing a fixture, retain
the existing screws for use with the new fixture.
5. Using suitable wire connectors (not provided), connect fixture wires to
supply wires (white to white or ribbed side of the fixture cord, black to black
or smooth side, and bare copper to bare copper or green supply). Push wires
back into outlet box.
Caution: Make sure wire connectors are twisted on securely, and no bare
wire is exposed.
6. Slide fixture canopy (D) against ceiling, and secure with canopy ring (E).
7. Once the fixture is fastened to the ceiling, tighten the set screw (K) in clutch
(J) firmly with hex wrench provided. Only after the set screw (K) is tight
should you install the lower assembly.
8. Refer to following instructions to install bulb and shade assembly.
(continued)
(Figure 3)