Hubbardton Forge 136303 User Manual

A202, Assembly & installation instructions

Advertising
background image

Assembly & Installation Instructions

A202

For Pendant 13-6303 & 13-6303E

Page 1 of 3

Hand-Forged,

Vermont-Made Lighting and Accessories

P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

22699 Rev A

Stem Assembly

(Figure 1)

Component Parts

A Fixture

Pipe

B Fixture

Coupling

1. Carefully unpack the fixture from the carton.
2. Carefully thread fixture pipe (A), threaded end first, over fixture wires.
3. Apply a drop of the supplied thread locking compound to the internal threads of the fixture

coupling (B) and screw stem into fixture, being careful not to twist the wires.

Note: Application of the thread locking compound is necessary to prevent the stem from
loosening during regular maintenance and cleaning of the fixture. Be certain to apply the
compound.

4. See instructions below to complete the installation.

Prepare the Canopy

(Figure 2)

Component Parts

C Jam Nut (2)
D Crossbar
E Threaded

Nipple

F Canopy
G Canopy

Ring

H Coupling
I Canopy

Pipe

Caution: Be sure power is off at the main breaker box prior to
installation.

1. Thread jam nuts (C) and crossbar (D) onto threaded nipple (E) leave

both parts loose.

2. Using two machine screws (not provided), temporarily fasten the

crossbar (D) to the electric box.

Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.

3. Adjust the length of threaded nipple (E) in crossbar (D) so that canopy

ring (G) will hold canopy (F) against the ceiling with no threads
showing for best appearance. When the correct adjustment is
established, tighten jam nuts (C) against crossbar (D) to hold the
adjustment.

4. Remove the crossbar and stem from the electrical box and proceed with

the assembly instructions.

(continued)

(Figure 1)

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

(Figure 2)

Advertising