Hubbardton Forge 137530F - Manual

Assembly & Installation Instructions
A179
For Ellipse Circular Adjustable Pendant 13-7530F Page 1 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21365
Stem Assembly (Figure 1)
Component Parts
A Fixture Pipe (3)
B Fixture Coupling (3)
1. Carefully unpack the fixture from the carton.
2. Carefully thread fixture pipe (A), threaded end first, over fixture
wires.
3. Apply a drop of the supplied thread locking compound to the
internal threads of fixture coupling (B) and screw stem into fixture,
being careful not to twist or pinch the wires.
Note: Application of the thread locking compound is necessary to
prevent the stem from loosening during regular maintenance and
cleaning of the fixture. Be certain to apply the compound.
4. See instructions below to complete the installation.
Assemble the Canopy Pipes (Figure 2)
Component Parts
C Cable Gripper
D Hex Nipple (2)
E Flat Washer (3)
F Lock
Washer (5)
G Support Ring
H Canopy Pipe
1. Apply a drop of the supplied thread locking compound to the external threads of
hex nipple (D). Slip flat washer (E) and two lock washers (F) over hex nipple
(D). Slip hex nipple (D) through support ring (G) and thread into canopy pipe
(H). Repeat with other hex nipple (D).
Note: Application of the thread locking compound is necessary to prevent the
stem from loosening during regular maintenance and cleaning of the fixture. Be
certain to apply the compound.
2. Slip flat washer (E) and lock washer (F) over cable gripper (C). Slip cable gripper
(C) through support ring (G) and thread into canopy pipe (H). Do not apply
thread lock to cable gripper at this point.
(continued)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)