Hubbardton Forge 137581 - Manual

Installation Instructions
A91
Large Bent Plane Pendant Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
19403
Stem Assembly (Figure 1)
Component Parts
A Fixture Pipe
B Fixture
1. Carefully unpack the fixture from the carton.
2. Carefully thread fixture pipe (A), threaded end first, over fixture wires.
3. Apply a drop of the supplied thread locking compound to the internal threads at
the top of the fixture (B) and screw stem into fixture, being careful not to twist
the wires.
Note: Application of the thread locking compound is necessary to prevent the
stem from loosening during regular maintenance and cleaning of the fixture. Be
certain to apply the compound.
4. See instructions below to complete the installation.
(Figure 1)
Complete Assembly & Install Fixture (Figure 2 below, Figures 3 & 4, next page)
Component Parts
A Crossbar
B Threaded Stud (2)
C Hanger
Plate
D Lag Screw (4)
E 1/4-20 Nut (2)
F Canopy
G Clutch
(2)
H Knurl Ball (2)
I Canopy Pipe
J Plastic Clutch Sleeve
K Fixture
Pipe
Caution: Be sure power is off at the main breaker box prior to installation.
1. Thread the wires from the fixture pipe (K) into and through
the canopy pipe (I) up through the canopy (F).
2. Unscrew the clutch (G) from the fixture pipe (K), slide it
across the wires and onto the canopy pipe (I). Follow this
with the plastic clutch sleeve (J), oriented so the tapered end
of the clutch sleeve nests in the clutch.
3. Slide the canopy pipe (I) as far as necessary to give you the
total length of the fixture which you desire. Be careful not to
scratch the pipe surfaces and to pull excess wire up through
the canopy (F). There must be a minimum 1-1/2" of inner
pipe inside the outer pipe. Hand-tighten the clutch to
temporarily hold this adjustment. The clutch is not securely
fastened at this point; do not depend on it to hold the fixture.
Important: To ensure full connection strength, be sure the tapered end of the plastic clutch sleeve is oriented toward the
clutch when assembled (Figure 2).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)