Hubbardton Forge 137610 - Manual

Assembly & Installation Instructions
A107
For Intersections Pendants 13-7605 & 13-7610 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19795 Rev A
To Attach Fixture Pipes (Figure 1)
Component Parts
A Fixture Pipe
B Fixture
1. Carefully unpack the fixture from the carton.
2. Carefully thread fixture pipe (A), threaded end first, over fixture wires.
3. Apply a drop of the supplied thread locking compound to the internal threads at the
top of the fixture (B) and screw stem into fixture, being careful not to twist the
wires.
Note: Application of the thread locking compound is necessary to prevent the stem
from loosening during regular maintenance and cleaning of the fixture. Be certain to
apply the compound.
4. See instructions below to complete the installation.
To Assemble Fixture (Figures 2 & 3)
Component Parts
C Canopy
D Canopy
pipe
E Clutch sleeve
F Clutch
G Set
Screw
H Fixture pipe
1. Slip the wires from the fixture pipe (H) into and through the canopy pipe (D)
up through the canopy (C).
2. Unscrew the clutch (F) from the canopy pipe (D); slide it across the wires and
onto the fixture pipe (H). Follow this with the plastic clutch sleeve (E), oriented
so the tapered end of the clutch sleeve nests in the clutch (Figure 3).
3. Slide the canopy pipe (D) as far as necessary to give you the total length of the
fixture which you desire. Be careful not to scratch the pipe surfaces and to pull
excess wire up through the canopy pipe (D). Screw clutch (F) onto canopy pipe
(D). There must be a minimum 1-1/2" of inner pipe inside the outer pipe.
Hand-tighten the clutch to temporarily hold this adjustment. The clutch is not
securely fastened at this point; do not depend on it to hold the fixture.
Important: To ensure full connection strength, be sure the tapered end of the
plastic clutch sleeve is oriented toward the clutch (Figure 3).
4. Stop. Please see installation instructions below.
(continued)
(Figure 2)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.