Hubbardton Forge 137620 - Manual

Assembly & Installation Instructions
A300
Facet Pendant 13-7620 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27150
To Install to Ceiling (Figures 1 thru 5)
Component Part
A Ceiling Bracket
B Cable Gripper (2)
C Gripper
Nut (2)
D Canopy
E Support Cable (2)
F Fixture
G Supply wire
H Strain Relief
I Washer
J Cupped
Washer
K Hex Nut
Caution: Be sure power is off at the main breaker
box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided),
fasten the ceiling bracket (A) to the electric
box.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.
3. Slip gripper nuts (C) onto the support cables
(E) and allow to rest on top of fixture (F).
4. Pull support cables (E) and supply wire (G)
through canopy (D) allowing canopy to rest on
top of fixture (F).
5. Raise fixture and push support cables (E)
through cable grippers (B) until desired fixture
height is accomplished and level.
6. Slip supply wire (G) through strain relief (H)
and push supply wire (G) through slot on the
bottom of ceiling bracket (A) followed by
washer (I). Adjust location of strain relief (H)
on supply wire (G) until it will snap into
location provided on ceiling bracket (A). Note:
Make sure orientation of slot in the ceiling
bracket matches location of supply wire from fixture.
7. Snap strain relief (H) onto supply wire (G) and push into tab on ceiling bracket (Figure 3).
8. Once support cables are at the correct height, excess cable can be cut off. To keep the strands of cable together a
small piece of electrical tape can be applied to the cut end.
9. Cut excess supply wire (G) allowing enough left (approx. 6”) to make connections in the electrical box. Strip
outside jacket being careful not to cut through shielding of the two inner conductors.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)