Hubbardton Forge 137860 - Manual (Page 3)

Assembly & Installation Instructions
A108
After Hours Pendant 13-7860F Page 3 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19820 Rev B
7. Using suitable wire connectors (not provided) connect fixture wires to supply (white to white or ribbed and black to
black or smooth). Connect all ground wires to green ground screw (E).
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
8. Slide canopy (C) over threaded studs (F) and push firmly to ceiling, making sure that no wires are pinched between
fixture canopy and ceiling. Fasten with barrel knobs (G). Be sure studs are fully seated in the barrel knobs.
9. Once the fixture is fastened to the ceiling, tighten the set screw (K) in clutch (J) firmly with hex wrench provided.
Only after the set screw (K) is tight should you install the glass.
10. Refer instructions below and install glass.
To Install Bulb and Glass
(Figure 4)
Component Parts
L Lock
M Glass
Frame
N Bulb (not included)
O Glass
Tube
P Bottom Plate
1. Unscrew lock (L) and slide lock (L), glass frame (M) up fixture stem.
2. Install bulb (N) into sockets. Orient bulb pins to slip in slots in the sockets. Turn the
bulb until the sockets lock in position. (Bulb should not be able to be pulled out of
sockets once it is locked in place).
3. Slip glass (O) over bulb (N) location and place inside glass frame (M).
4. Lower glass frame (M) and glass tube (O) so that the bottom notches are aligned with
the tabs on the bottom plate (P).
5. Screw lock (L) down on top of glass frame (M) until tight.
If you need further assistance, or find that you are missing any parts, please contact the
dealer from which you purchased this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 4)