Hubbardton Forge 138552 - Manual

Installation Instructions
A92
Ondrian Pendant 13-8550 & 13-8552 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 19404 Rev B
To Assemble Canopy & Pipes
(Figures 1, 2 & 2A)
Component Parts
A Canopy
B Clutch
(2)
C Canopy Pipe (2)
D Plastic Clutch Sleeve (2)
E Fixture Pipe (2)
F Set Screw (2)
AA Support Cable
BB Cable Gripper
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Thread the wires and support cable (AA) from the fixture pipe (E)
up through the canopy (A), then into and through the canopy pipe
(C).
Note: Be sure to include the canopy in this step, or it will not
be possible to complete the installation. Note: Cable and wires
are in separate pipes.
3. Unscrew the clutch (B) from the fixture pipe and slide it across
the fixture wires and onto the canopy pipe (C). Follow this with
the clutch sleeve (D) so that the clutch sleeve nests in the clutch.
4. Slide the canopy pipe into the fixture pipe as far as necessary to
give the total fixture length desired. Be careful not to scratch the
pipes and to pull excess wire up through the canopy stem. There
must be a minimum of 1-1/2" of inner pipe inside the outer pipe.
Tighten the clutch onto the fixture pipe and secure by firmly
tightening the set screw (F).
Important: To ensure full connection strength,
be sure the tapered end of the plastic clutch sleeve is oriented toward the clutch when assembled (Figure 2).
5. Push support cable (AA) through cable gripper (BB) until cable is tight and has no slack. Once support cable is at
the correct height, excess cable behind the gripper can be cut off (Figure 2A).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2) (Figure 2A)
(Figure 1)