Hubbardton Forge 207871 - Manual

Installation Instructions
B106
Exos Wave Sconce Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Install Fixture (Figure 1)
Component Parts
A Wall Mount Bracket
B Anchors
(4)
C #10 Screws (4)
D Fixture
E #8 Black Screws (2)
F Green Ground Screw
G Cupped
Washer
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the
carton.
2. Center the wall mount bracket (A) over the
electrical box being sure to hold it plum and
level. With a pencil, mark the location of all
mounting holes in the wall mount bracket on
the wall behind.
IMPORTANT: Wall mount bracket must be
secured to a solidly mounted electrical box
and/or a framing member in at least two
locations. Do not depend on drywall anchors
alone to support this fixture. If in doubt,
contact a qualified electrician.
Put the wall mount bracket down and drill
1/4" holes in the locations marked on the
wall. For holes using anchors, place the
tapered end of the anchors (B) into the holes
and gently tap them flush to the wall using a
light weight hammer.
3. Thread the wires in the electrical box
through the center hole in the wall mount bracket while
moving the bracket into position. Using the 1" #10
screws (C), screw the bracket securely to the wall. Be careful not to over-tighten or strip the anchors. (Figure 1)
4. Hold the fixture assembly (D) close to the wall mount bracket and using suitable wire connectors (not provided),
connect fixture wires to supply wires (white to white, black to black, and bare copper or green to bare copper or
green). Ground the mounting bracket using the green ground screw (F) and cupped washer (G) to secure a pigtail
lead to the bracket.
Caution: Make sure wire connectors are twisted on securely, and no bare wires are exposed.
(continued)
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19499 Rev B