Hubbardton Forge 137527 - Manual

Assembly & Installation Instructions
A216
For Ellipse Large Five Light Pendant 13-7527 & 13-7527E Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22885
Install Fixture Pipes (Figure 1)
Component Parts
A Fixture Pipe (2)
B Fixture Coupling (2)
C Support
Cable
1. Carefully unpack the fixture from the carton.
2. Carefully thread fixture pipe (A), threaded end first, over fixture
wires and support cable (C).
3. Apply a drop of the supplied thread locking compound to the
internal threads of fixture coupling (B) and screw pipe into fixture,
being careful not to twist or pinch the wires.
Note: Application of the thread locking compound is necessary to
prevent the stem from loosening during regular maintenance and
cleaning of the fixture. Be certain to apply the compound.
4. See instructions following to complete the installation.
Install Canopy Pipes (Figure 2)
Component Parts
D Canopy Coupling (2)
E Canopy Pipe (2)
F Decorative Caps (2)
1. Apply a drop of the supplied thread locking compound to the internal
threads of canopy coupling (D) and screw canopy pipe (E) into coupling.
Note: Application of the thread locking compound is necessary to prevent
the stem from loosening during regular maintenance and cleaning of the
fixture. Be certain to apply the compound.
2. Thread decorative caps (F) to bottom of canopy pipes (E).
3. See Figure 6. Remove barrel knobs (O) and wireway cover (N) from
canopy. Save for later use.
4. See instructions following to complete the installation.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)