Hubbardton Forge 137531 - Manual

Assembly & Installation Instructions
A217
For Ellipse Large Nine Light Pendant 13-7531 & 13-7531E Page 1 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22896
Stem Assembly (Figure 1)
Component Parts
A Fixture Pipe (3)
B Fixture Coupling (3)
C Support Cable (3)
D Decorative Caps (3)
1. Carefully unpack the fixture from the carton.
2. Carefully thread fixture pipe (A), threaded end first, over
fixture wires.
3. Apply a drop of the supplied thread locking compound to
the internal threads of fixture coupling (B) and screw
stem into fixture, being careful not to twist or pinch the
wires.
Note: Application of the thread locking compound is
necessary to prevent the stem from loosening during
regular maintenance and cleaning of the fixture. Be
certain to apply the compound.
4. Thread decorative caps (C) to top of fixture pipes (A).
5. See instructions below to complete the installation.
Install Canopy Pipes (Figure 2)
Component Parts
E Canopy Coupling (3)
F Canopy Pipe (3)
1. Apply a drop of the supplied thread locking compound to the internal threads
of canopy coupling (E) and screw canopy pipe (F) into coupling.
Note: Application of the thread locking compound is necessary to prevent the
stem from loosening during regular maintenance and cleaning of the fixture. Be
certain to apply the compound.
2. See instructions following to complete the installation.
(continued)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)