Hubbardton Forge 205305 - Manual

Installation Instructions
B232
Callas Sconce 20-5305 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 26934
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
After installation extra hardware and accessories are possible due to our kits are used on multiple products and options.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Fixture
B Crossbar
C Threaded Stud (2)
D Knurl Ball (2)
E Ground
Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not
provided), fasten the crossbar (B) to
the electric box making sure that
fixture mounting holes are level.
Note: A new electric box comes
with screws. When replacing a
fixture, retain the existing screws for
use with the new fixture.
3. Thread studs (C) into the
appropriate holes in the crossbar
(B). Adjust the studs to proper
length to ensure the fixture will fit
snugly to the wall.
4. Hold the fixture (A) close to the
wall and using suitable wire
connectors (not provided) connect
fixture wires to supply (white to
white or ribbed and black to black
or smooth). Run a pigtail lead from
crossbar ground screw (E) to the
junction box and connect all ground
wires (bare copper or green to bare
copper or green).
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
5. Slide fixture (A) over threaded studs (C) and push firmly to wall, making sure that no wires are pinched between
fixture and wall. Fasten with knurl balls (D). Be sure threaded studs (C) are fully seated in the knurl balls (D).
6. See instructions following to complete installation.
( continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)