Hubbardton Forge 207650 - Manual

Installation Instructions
B222
For Brindille Sconce 20-7650 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 26509
For fixtures requiring assembly, please refer to assembly instructions before installation.
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Crossbar
B Threaded Stud (2)
C Knurled Balls (2)
D Fixture
Assembly
E Ground Screw
Caution: Be sure power is off at the
main breaker box prior to installation.
1. Carefully unpack the fixture
from the carton.
2. Using two machine screws (not
provided), fasten the crossbar
(A) to the electric box making
sure that fixture mounting holes
are level.
Note: A new electric box comes
with screws. When replacing a
fixture, retain the existing screws
for use with the new fixture.
3. Thread studs (B) into the
appropriate holes in the crossbar
(A). Adjust the studs to proper length to ensure the fixture will fit snugly to the wall.
4. Hold the fixture assembly (D) close to the wall and using suitable wire connectors, not provided, connect fixture
wires to supply (white to white or ribbed and black to black or smooth). Run a pigtail lead from crossbar ground
screw (E) to the junction box and connect all ground wires (bare copper or green to bare copper or
green).
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
5. Slide fixture assembly (D) over threaded studs (B) and push firmly to wall, making sure that no wires are pinched
between fixture back and wall. Fasten with knurled balls (C). Be sure threaded studs (B) are fully seated in the
knurled balls (C).
6. See instructions on next page to install shade.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)