Hubbardton Forge 206745 - Manual

Installation Instructions
B47
For Forged Wave Sconce 20-6745L & 20-6745R Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 16163 Rev A
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall (Figure 1)
Component Parts
A Crossbar
B Threaded Stud (2)
C Knurl Ball (2)
D Fixture
Assembly
E Ground Screw
Caution: Be sure power is off at the main breaker box
prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten
the crossbar (A) to the electric box making sure
that fixture mounting holes are level.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use
with the new fixture.
3. Thread studs (B) into the appropriate holes in the
crossbar (A). Adjust the studs to proper length to
ensure the fixture will fit snugly to the wall.
4. Hold the fixture assembly (D) close to the wall
and using suitable wire connectors, not provided,
connect fixture wires to supply (white to white
or ribbed and black to black or smooth). Connect
all ground wires to ground screw.
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
5. Slide fixture assembly (D) over threaded studs (B) and push firmly to wall, making sure that no wires are pinched
between fixture back and wall. Fasten with knurl balls (C). Be sure threaded studs (B) are fully seated in the
knurl balls (C).
6. See instructions on next page to install glass.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)