Hubbardton Forge 277690 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2014 Hubbardton Forge ® . All rights reserved. 30863
Shade Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
To Install Harp & Shade (Figures 1 & 2)
Component Parts
A Turn Knob
B Harp Holder
C Socket
D Locks (2)
E Harp
F Finial
G Shade
H Diffuser
I Washer
1. Carefully unpack the lamp from the carton.
2. Install turn knob (A) onto socket (C) (Figure 1).
3. Remove finial (F) and washer (I) from harp (E) and save for
later use. Finial and Washer are shipped installed on harp.
4. Squeeze harp (E) together while holding the locks (D) up
towards the top of the harp (E) and slip into harp holder (B).
5. Allow locks (D) to slip down harp (E) and onto harp holder (B)
to secure harp in place.
6. Install bulb. Bulb is included with the “C” version.
7. Slip shade (G), diffuser (H) and washer (I) onto threaded stud
on top of harp (E). See Figure 3 for washer orientation.
8. Thread finial (F) onto threaded stud on harp (E) and tighten
until snug. Be careful not to over tighten.
C59
Arbo Table Lamps 277690 & 277690C Page 1 of 1
(Figure 1)
C
A
B
D
(Figure 2)
E
F
G
D
(Figure 3)
CORRECT ORIENTATION WRONG ORIENTATION
FINIAL
WASHER
TOP OF DIFFUSER
FINIAL
WASHER
TOP OF DIFFUSER