Hubbardton Forge 123252F - Manual

Assembly & Installation Instructions
A147
For Semi-Flush Vortis Fixtures 12-3250F & 12-3252F Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21183
To Install Fixture (Figure 1)
Component Parts
A Ground Screw
B Cross Bar
C Threaded Stud (2)
D Canopy
E
Barrel Knobs (2)
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Thread studs (C) through appropriate holes in cross bar (B) to match
hole centers in canopy (D). Move ground screw (A) to another
available threaded hole if necessary.
3. Using two machine screws (not provided) fasten cross bar (B) to the
electric box using outer oval holes to orient fixture to desired
hanging position.
Note: A new electric box comes with screws. When replacing an
existing fixture, retain the screws for use with the new fixture.
5. Using suitable wire connectors (not provided); connect fixture wires
to supply wires (white to white and black to black). Connect all ground wires
to green ground screw (A).
Caution: Make sure wire connectors are twisted on securely, and no bare wire
is exposed.
6. Slide fixture canopy (D) over threaded studs and push firmly to ceiling, making
sure that no wires are pinched between fixture canopy and ceiling. Fasten with
barrel knobs (E). Be sure studs (C) are fully seated in barrel knobs (E).
To Install Bulb (Figure 2)
Component Parts
F Bulb Retainer
G Ballast
H Bulb
I Retainer Plate
J Screw (4)
1. Remove the retainer plate (I) by loosening and removing the four screws (J).
2. Plug connection from ballast (G) to four pin location on bulb (H).
3. Snap bulb (H) in to bulb retainer (F).
4. Replace the retainer plate (I) and the four screws (J) and tighten.
(continued)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)