Hubbardton Forge 123307 - Manual

Assembly & Installation Instructions
A258
Semi-Flush Kirigami Four Light 12-3305 & 12-3307 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 24793 Rev D
To Install Fixture (Figure 1)
Component Parts
A Ground Screw
B Cross Bar
C Threaded Stud (2)
D Canopy
E Barrel Knobs (2)
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Thread studs (C) through appropriate holes in cross bar (B) to
match hole centers in canopy (D). Move ground screw (A) to
another available threaded hole if necessary.
3. Using two machine screws (not provided) fasten cross bar (B) to
the electric box using outer oval holes to orient fixture to desired
hanging position.
Note: A new electric box comes with screws. When replacing an
existing fixture, retain the screws for use with the new fixture.
4. Using suitable wire connectors (not provided); connect fixture
wires to supply wires (white to white and black to black). Run a
pigtail lead from crossbar ground screw (A) to the junction box
and connect all ground wires (bare copper or green to bare copper
or green).
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
5. Slide fixture canopy (D) over threaded studs and push firmly to
ceiling, making sure that no wires are pinched between fixture
canopy and ceiling. Fasten with barrel knobs (E). Be sure studs
(C) are fully seated in barrel knobs (E).
(continued)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.