Hubbardton Forge 365610 - Manual

Installation Instructions
A192
For Meridian Chain-Hung Fixture 36-5610 & 36-5610F Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22418
To Install Fixture (Figure 1)
Component Parts
A Lock Nut
B Crossbar
C Cupped
Washer
D Ground Screw
E Threaded Stud (2)
F Nipple
G Wood Screws (4)
H Canopy
I Canopy
Loop
J Cover Plate
K Knurl Ball (2)
L Chain
M Fixture
Loop
N Fixture Top
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Thread studs (E) through appropriate holes in crossbar (B) to match
holes in canopy (H).
3. Thread the nipple (F) into the crossbar (B) and secure with lock nut (A).
4. Thread canopy loop (I) onto nipple (F).
5. Attach one end of the chain (L) to the fixture loop (M). Lace the wire
through every other link of the chain (L) to the end.
6. Slide cover plate (J) and canopy (H) over chain (L) until they rest
against fixture top (N).
7. Fasten the chain (L) to the canopy loop (I) and slip wires through the
canopy loop (I) and nipple (F). Make sure to provide enough slack in
the wire to ensure weight of fixture is supported by the chain.
8. Raise fixture to ceiling and using at least two wood screws (G) attach
cross bar (B) to a structural member in the ceiling, centering the
crossbar over the outlet box. We've supplied wood screws with your
fixture; however, different materials and/or construction methods may
require different fasteners. If in doubt, contact a qualified electrician. Do
not attach crossbar directly to outlet box.
9. Using suitable wire connectors (not provided) connect fixture wires to
supply wires (white to ribbed side of the fixture cord, black to smooth
side). Connect all ground wires to cupped washer (C) and ground screw
(D).
Caution: Make sure wire connectors are twisted on securely, and
no bare wire is exposed.
10. Slide canopy (H) and cover plate (J) over threaded studs (E) and push
firmly to ceiling, making sure that no wires are pinched between fixture
canopy and ceiling. Fasten with knurled balls (K). Be sure studs (E) are
fully seated in the knurled balls (K).
11. Install glass (see instructions on next page).
(continued)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.