Blodgett BPBB SERIES - Manual (Page 9)

P/N 3000012219 REV. A Page 9
HI-SHELF /RISER INSTALLATION
1. Remove the existing riser from the unit.
2. Slide the riser support assembly into the back of the appliance as shown in
the illustration below.
3. Slide the riser support assembly toward the front of the range.
4. Install the bolts through the slots with washers as shown.
5. Tighten all bolts securely.
6. Slide the stainless steel shroud over the riser support.
7. Install rear panel and tighten securely.
8. Install the flue diverter.
Figure 4: Installing Hi-Shelf/Riser
MOUNTING SALAMANDER or CHEESEMELTER
CAUTION: Salamander (BP-SB model) and Cheesemelter (BP-CM model) models
require a “reinforced” riser for range mounting.
For the installation of a salamander or cheesemelter on the riser of a Phoenix range,
please refer to the Installation and Operation manual provided with the accessory unit.
Order the range mount and interconnect gas line kit (optional) to install these units.
Assembly riser using
¼-20 Bolts and washers