Spektrum SPM20310 DX3.0 - Manual (Page 25)


Lap Timer
(Function Mode)
The Lap Timer function of the DX3.0 allows the recording of individual lap times based on a
999 second up-timer. Up to 50 laps and times from 3.0 to 99.9 seconds can be stored in
memory for review at a later time. The Lap Timer function will only be enabled and shown in
Function mode if Grip Button C (System Mode) is set to “LA.” With the Lap Timer enabled,
pressing the channel key will alternate between the Normal display screen and Up-Timer
display screen.
The Lap Timer is started by pressing Grip Button C. Once active, as shown by the blinking word
“LAP,” pressing Grip Button C again will begin recording the time of the next lap.
Note: A 3.0 second lap is the quickest lap allowed. This prevents accidental double pushing of
Grip Button C when recording lap times. If more than 50 laps are recorded, each new lap will
overwrite the oldest lap held in memory.)
To stop the Lap Timer, press the Increase and Decrease keys at the same time. To restart the Lap
Timer, press Grip Button C. To reset the Up-Timer, press the Channel key to show the Up-Timer
display screen. With the Up-Timer stopped, press the Increase and Decrease keys at the same
time to reset.
To review or reset lap times you must be in the Lap Timer function mode screen. Upon entering
this function, the screen will always show the last lap time recorded. Use the
Increase or Decrease keys to view the desired lap(s).
Note: If a recorded lap time is greater than 99.9 seconds, “OVR” will be displayed.
To clear all lap times, press the Increase and Decrease keys at the same time.
Accessing the Lap Timer Function
1. Turn the transmitter power switch on.
2. Press the
SCROLL key to access Function mode.
3. Press the SCROLL key until “LAP” appears in the screen.
4. Press the INCREASE or DECREASE keys to view the desired lap time(s).
5. To reset all lap times, press the INCREASE or DECREASE keys at the same time.
6. Press the SCROLL key to access the Sub-Trim function.
7. To exit the Function mode, either turn the transmitter power switch off or press the
SCROLL and CHANNEL keys at the same time.
0I
0
L A P
–
Recorded Lap Time to 1/10th of a second
(i.e. 40.1 sec.)
Current Lap Number