Spektrum SPM4200 DX4C - Manual (Page 5)

5 SPEKTRUM DX4C • TRANSMITTER INSTRUCTION MANUAL
EN
THE RUBBER GRIP
This transmitter includes 3 sizes of grips. The medium-size grip
is installed at the factory.
To change the rubber grip
1. Lift the edge of the grip and pull the grip away from the
handle.
2. Align the tabs on the new grip with the slots in the handle.
3. Press the grip against the handle.
MODELMATCH
The Spektrum DX4C transmitter features ModelMatch™
technology, preventing you from operating a vehicle when the
wrong model memory is active in the transmitter. If you select
the wrong model memory, the receiver will not respond to
the transmitter.
1. Remove the grip from the back of the transmitter handle.
2. Download the latest RaceWare fi rmware from
www.SpektrumRC.com to an SD card. The transmitter serial
number can be found by going to the About screen.
3. Install the SD card in the card reader slot on the DX4C
transmitter.
4. Power on the transmitter. A Spektrum logo and an installation
bar will appear. Installation is complete when the Main screen
appears.
5. Power off the transmitter.
6. Remove the SD card from the card slot on the transmitter.
7. Re-install the rubber grip on the transmitter handle.
The DX4C features an SD card reader, enabling you to update
the transmitter when RaceWare™ fi rmware updates are
available. Register your transmitter at www.SpektrumRC.com
to receive the latest information regarding RaceWare fi rmware
updates. To install RaceWare fi rmware updates on your DX4C
transmitter:
RACEWARE FIRMWARE UPDATES