Spektrum SPM3300 DX3C Manual - Manual (Page 7)

7 Spektrum DX3C • Radio Instruction Manual
EN
Roller and LCD Screen Use
This transmitter features one-touch programming using a
Rolling Selector. The Rolling Selector has three functions:
Pressing the Selector - enters the selected function.
Rolling the Selector - highlights function or changes settings
and values when selected.
Pressing and holding the Selector for more than 3 seconds
from any screen - returns the display to the Main Screen.
Programming always starts with a press on the selector, then a
roll, then a press, then a roll and so on.
Some racers find it convenient to use a thumb to make
programming changes. The roller’s location allows a racer to do
one-handed programming, controlling the model with one hand
while making programming adjustments with the other.
“Sticky” (GUI)
In the Travel, Expo, Mixing and Steer Mixing Screens, sticky
gooey (GUI) makes value adjustment easier. When you move
the channel control (the steering wheel or throttle trigger) to the
desired position and release, the value on the screen for that
side remains highlighted. Move the control the opposite direction to highlight the other
value on the screen. You do not have to hold the control in the
desired position for the value to be changed. Highlight both val-
ues on the screen again by pressing the Rolling Selector twice
with the control centered.
List
Select
Reverse
Travel
Expo
Bind
Sub-Trim
Timer
Name
Switch
System
Copy
Reset
Mixing
Steer Mix
System
Username
RS Port
Alert
Contrast
Buzzer
Lang
RF Mode
About...
List
Select
Reverse
Travel
Expo
Bind
List
Sub-Trim
Timer
Name
Switch
System System
List
System
Copy
Reset
Mixing
Steer Mix
PROGRAMMING GUIDE
Turn Press Press
Enter, Choose or
Exit
Move between options or
change value in an option
Hold for 3 seconds and release
to move to a higher screen
Turn Hold Press
List
The List Screen shows other screens to set programming in the transmitter.
A A dark box around with a clear symbol or text shows highlighted selection. Available
screens are Select, Reverse, Travel, Expo, Bind, Sub-Trim, Timer, Name, Switch,
System, Copy, Reset, Mixing and Steer Mix.
B Active Screen name shows at the top of the screen.
C Choosing this arrow will open the next higher screen, such as Main Screen or this List
Screen.
D A small bar shows relative position of highlighted screen name in the List.
List
B
D
C
A Model
Reverse
Travel
Expo
Bind
Model