Antec VSK-1000 - Manual (Page 8)

7
2.1 S ETTING U P
1.
Place the case upright on a flat, stable surface with the
rear of the case facing you.
2. Remove the side panels by first removing the
thumbscrews at the rear of the case. Then, grip each
panel at the top and bottom and slide it toward the rear
of the case until it detaches from the chassis.
Note: Do not use your fingernails to pry or lift the panels.
2.2 P OWER S UPPLY I NSTALLATION
1. With the case on its side, align your power supply with the power
supply mounting location near the top panel of the case.
Note: Power supplies with fans on the bottom of the power supply
will need to be mounted so that the fan is facing the bottom of the
case.
2. Attach the power supply to the case with the screws provided.
Note: Power supplies with fans on the bottom of the power supply will need to be mounted so that the
fan is facing the top of the case. The VSK-1000 provides mounting holes for power supplies with
standard mounting layouts to be installed upside up or upside down.