Antec VSK-1000 - Manual (Page 9)

8
2.3 M OTHERBOARD I NSTALLATION
1. Lay the case down, with the open side facing up. The
drive cages and power supply should be visible.
2. Make sure you have the correct I/O panel for your
motherboard. If the panel provided with the case isn’t
suitable, please contact your motherboard
manufacturer for the correct I/O panel.
3. Align your motherboard with the standoff holes and
remember which holes are lined up. Not all
motherboards will match with all the provided holes;
this is normal and won’t affect its functionality.
4. Remove your motherboard by lifting it up.
5. Install standoffs as needed and put the motherboard
back in.
6. Screw in your motherboard to the standoffs with the
provided Phillips-head screws.
2.4 I NTERNAL 3.5” D EVICE I NSTALLATION
The VSK-1000 provides space for up to six 3.5” hard
drives.
1.
Insert your 3.5” device into the 3.5” drive cage from
the rear of the cage until the mounting holes align
with the screw holes in the cage.
2. Fasten the device in place with the provided screws.
3. Mount any other 3.5” HDD devices accordingly.
4. Connect the appropriate power and data cables to the
device(s).