Nikon LS-2000 - Manual (Page 20)

10
3. Setup
Nikon LS-2000 35 mm Film Scanner User’s Guide
Step 4—Connect the SCSI cable
The LS-2000 connects to your computer by a Small Computer
Systems Interface, or SCSI. To use a SCSI connection, you will
need an appropriate SCSI cable and, in the case of IBM PC/AT
compatible computers, a SCSI extension board (“SCSI adapter”) or
PCMCIA card (see the FastTrack Guide and the LS-2000 Reference
Manual for details). This section describes the procedure to con-
necting the LS-2000 to a SCSI “chain” made up of your computer
and SCSI devices connected to it in a series.
SCSI devices cannot be connected while the power is on. Before
connecting the scanner to the SCSI chain, be sure that the computer
and all other devices in the chain, including the scanner, are off.
How the scanner should be connected to the chain depends on
whether it is to be located between other devices or attached at the
end of the chain.