Nikon L19 - L20 User Manual
Page 25
13
Inserting the Batteries
First Ste
p
s
B
Removing the Batteries
Confirm the power-on lamp and the monitor are off and open the battery-chamber/ memory card
slot cover.
B
Additional Precautions Regarding Batteries
• Read and follow the warnings and cautions (A iii, 107).
• Be sure to read and follow the warnings for the battery on page iii and the section, “The Battery”
A 107), before using the battery.
• Do not combine old and new batteries or batteries of different makes or types.
• Batteries with the following defects cannot be used:
B
Notes for EN-MH1 Rechargeable Batteries, MH-70/71 Battery Charger
This camera can also use EN-MH1 Ni-MH rechargeable batteries.
Be sure to read and follow the warnings for the battery found in the section, “The Battery” (
before using the battery.
B
Battery Type
To improve battery performance, select the type of battery currently inserted in the camera in the
setup menu. The default setting is the type of battery supplied with purchase. When any other type
of battery is used, turn the camera on and change the setting (
C
Alkaline Batteries
Performance of alkaline batteries may vary greatly depending on the manufacturer. Choose a
reliable brand.
C
Alternative Power Resources
To power the camera continuously for extended periods, use an AC Adapter EH-65A (available
separately) (
A 104). Do not, under any circumstances, use another make or model of AC
adapter. Failure to observe this precaution could result in overheating or in damage to the camera.
C
Auto Power-Off (Standby Mode)
If no operations are performed for about 30 seconds (default setting), the monitor turns off and the
camera enters standby mode. After a further three minutes, the Auto off function will turn the camera
off automatically. While the monitor is off during standby mode, it will turn on again when the power
switch or shutter-release button is pressed. The amount of time that passes before the camera enters
standby mode is determined by the Auto off setting (
A 94) in the setup menu (A 82).
Batteries with peeling
Batteries with insulation that
does not cover the area
around the negative terminal.
Batteries with a flat
negative terminal