Nikon LS-3500 - LS-3510 - Manual (Page 23)

Software Installation - IBM 2-3
Software Reference for Scanners
Fig. 7 Selecting the active scanner for PhotoStyler
You must choose which scanner driver to make active in PhotoStyler. Since
only one driver is available, click OK.
Your drivers are now installed and you can proceed on to the Getting Started
section for the Windows plugins.
Interface Hardware for PC Compatibles
For complete information on installation of GPIB hardware consult your GPIB
installation manual which comes with your GPIB board.
As with any interface board installation, ensure that there are no address,
interrupt or DMA channel conflicts between any boards installed in your
computer.
GPIB (General Purpose Interface Bus)
Currently, only the National Instruments AT-GPIB and MC-GPIB boards are
supported. When installing the software drivers for these boards, be sure to select
the installation for Windows. National Instruments can be reached at
1-800-IEEE-488 (1-800-433-3488).
SCSI (Small Computer Systems Interface)
Any SCSI board with ASPI (Advanced SCSI Programming Interface) drivers
should work, but only the T128 and T228 from Trantor and the AHA-1520, AHA-
1522, AHA-1540B, AHA-1542B, AHA-1640 and AHA-1642 from Adaptec have
been verified. Trantor can be reached at 1-510-770-1400 and Adaptec can be
reached at 1-800-869-8883. The ASPI drivers may not be included with the
standard software bundle and may have to be specifically requested.